View Full Version : Mag 7 Question
dbdavid
12-04-2003, 08:57 PM
Hi, I have a Mag 7 that I am currently using in an external closed loop with a SQWD water rotating device. my question is how hot do these pumps normally run? I can't keep my hand on the pump housing for more than 4-5 seconds as it is too hot! :eek: Is this normal for a Mag pump?
Dave
Aquattro
12-04-2003, 09:10 PM
Dave, the only external pump I have is a MAG 2, and it doesn't hardly get warm. I would say it shouldn't get that hot.
dbdavid
12-04-2003, 09:14 PM
Thanks Brad, I didn't think that it should be that hot. I have never owned a Mag pump before so I wasn't sure. I will take it apart and see what's up!
Dave
Delphinus
12-04-2003, 10:35 PM
Is the input restricted at all? Any number of 90 degree bends or lifting, and what size is the pipe on the intake side of the pump?
dbdavid
12-05-2003, 04:03 PM
Hi Delphinus, I am using 1" pipe but it is restricted to 3/4 due to the SQWD being inline. The head height is about 2 feet and there are quite a few 90's. Here is a diagram:
http://www.canreef.com/photopost/data/500/453closed_loop-med.jpg?7529
Dave
Aquattro
12-05-2003, 04:08 PM
I believe Adam (One_divided) has the exact same setup. Maybe PM him
Quinn
12-05-2003, 04:48 PM
I have a Mag12 as a return and a Mag5 on my CA reactor and they are both cool to the touch.
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.