Front Of Tank Flexing!!!

[reefcat]

I ahve a 35g tank that is fairly old (maybe 10 years) and when I looked at it from the right angle the whole front pane was flexing, not much but enough to notice.. should i be worried??

[fkshiu]

Yes.

[reefwars]

I'd be scared to death lol I would think about getting a new tank before yours cracks:) 35g Tank-$50- losing your system on the floor alot more expensive :) goodluck

[untamed]

Glass tank? If it was acrylic, I wouldn't be too concerned. Glass...yikes!

[paddyob]

I ahve a 35g tank that is fairly old (maybe 10 years) and when I looked at it from the right angle the whole front pane was flexing, not much but enough to notice.. should i be worried??



I have heard that it is normal to have a little bit of a flex in the glass. Pressure pushing outwards.

[Spiny]

some deflection can be acceptable. However, if I were you, I'd drop the water level, put a temporary clamp then silicone a brace there (if the front is deflecting, the back probably is too)

[reefcat]

some deflection can be acceptable. However, if I were you, I'd drop the water level, put a temporary clamp then silicone a brace there (if the front is deflecting, the back probably is too)


So are you saying to to 2 clamps at each end of the tank at the top and like silicone on like a wood brace to hold it at the top like the bottom does.

[Ryanst]

My old 220 gallon tank flexed alot. Never broke or cracked though but I worried about it happening

[zum14]

My old 125 hagen freshwater flex's a fair bit as well. It came from the factory like that and has worked this long. I definitly keep a close eye on it though. Its also like close to 5/8 glass too.

[snow1]

I had a 42g tank do this to me once. I did not want to take the chance so I went on craigslist and bought a cheap tank to replace it. I think you should do the same..why worry about it?

[bvlester]

he is saying you can get a piece of glass cut and silicone it in place across the top from the front pane to the back pane of glass. the will stop the flexing.

Bill

[Spiny]

So are you saying to to 2 clamps at each end of the tank at the top and like silicone on like a wood brace to hold it at the top like the bottom does.

actually no, I'd just put clamps enough to make the pannels straight, then I'd use a strip of glass and make a kind of eurobrace just for the front and back (or complete eurobrace if you feel like it)

something like this:

(that's my 120g when I made it)
http://i777.photobucket.com/albums/yy53/SpinyReef/96eurobrace.jpg

Make sure you use good quality non toxic silicone

[Sean]

Just me but that tank is small enough and old enough that you got your moneys worth, I would consider getting a new one just for peice of mind.. I mean if you start messing around with home made fixes you might make the tank angry. ;)

[mark]

flexing? do you have a wave-maker or surge?

[Reelgator]

My email is here from Bulk Reef Supply

Thanks David for putting this together!:biggrin:

Reel Gator

[StirCrazy]

ok how much deflection is there. glass does deflect and depending on the amount it may or may not be an issue. get a nice strait edge preferably as long as the tank and lay it across the front and measue the gap at the ends. my tank flexed 1/32 of an inch when I took the center brace out which is nohing to worry about. I have seen some tanks flex up to a 1/4" and it wasn't a problem. it all depends on the thickness of the glass, and the hight and lenght of the glass.

Steve

[Mech Eng]

In larger tanks glass flexing is normal. However in a small tank like you have if the tank is noticeably (you can tell when looking at it from the side) the glass is aging and starting to weaken (UV light will do this over a period of many years in lower quality or older glass types). Glass gets its strength from its rigidity, as it flexes the strength diminishes. The flexing will also put stress on the silicon glue once aged (silicon losses its flexibility over time with UV light).

In short, replace the tank.

Its always a good time to upgrade to a larger tank when replacing an old one :biggrin:

If you are looking at used, look for a reputable brand and inspect it filled.