View Full Version : ply wood tank
Alleycat_99
03-27-2010, 03:39 PM
Has anyone done this or herd of this???
I want to make 2 cube tanks from ply wood and fiberglass and use my existing 80 gal to make a podium type tank. I would take the front and 2 sides of the 80 and silicone it to the 2 cubes and then get a new front made up and silicone it and make a few cross braces for extra support?? What do u guys think
hillbillyreefer
03-27-2010, 04:06 PM
A rough sketch may help.
Alleycat_99
03-27-2010, 04:20 PM
Will add later when I get home
fencer
03-27-2010, 04:32 PM
GARF.org has a plywood tank calculator. I have built many of these tanks in yrs past
TheKid
03-27-2010, 04:35 PM
What are ply wood tanks and what are they used for??:neutral:
fkshiu
03-27-2010, 04:43 PM
Plywood tanks are great for large applications where glass/acrylic would be too heavy/expensive/ungainly since plywood is cheap and can be built on site with regular wood tools. Plywood tanks are also good for in-wall tanks since you only need one transparent side.
They are essentially inside-out boats with the wood on the outside and the fibreglass/epoxy coating on the inside.
whatcaneyedo
03-27-2010, 11:48 PM
This TOTM was a plywood tank http://reefkeeping.com/issues/2007-11/totm/index.php
dean9922
04-07-2010, 01:59 PM
I've built a 100 gallon and a 76 gallon plywood tank. They have been running for a year now with no problems at all.....i used the Garf.org site for both plans. If you do this and use resin, make sure to use fibreglass tape on all seems....just gives a better seal....good luck and pm me any questions you may have and I can send you some pictures.
soapy
04-07-2010, 03:55 PM
Here is another site where a guy builds a plywood tank
http://www.jonolavsakvarium.com/eng_diy/2200litre/2200litres.html
Also check out his tank blog on keeping cold water organisms:
http://www.jonolavsakvarium.com/blog/index.html
Wood makes good sense for a large coldwater tanks since you will probably insulate four sides to keep in the cold anyways.
Okguy
04-07-2010, 05:34 PM
This TOTM was a plywood tank http://reefkeeping.com/issues/2007-11/totm/index.php
Fudge is a member of Canreef. His full build link is attached below. I was sad to read it was shut down and sold.
http://www.canreef.com/vbulletin/showthread.php?t=31113&highlight=fudge
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.