PDA

View Full Version : Nano Wall Mount Project Idea


sitandwatch
03-11-2009, 08:58 PM
Just found this tank says it 6.6 Gal could be a fun project for someone.

A wall mounted Nano.

http://www.canreef.com/vbulletin/picture.php?albumid=84&pictureid=776

http://www.aquavistainc.com/home.html

Rbacchiega
03-11-2009, 09:13 PM
interesting idea, but I doubt it would last very long as a thriving tank.

There's a thread somewhere on RC where they took a tank and made it look like it was on the wall. Very interesting design and outcome.

These tanks just seem too thin to even bother I think

Borderjumper
03-11-2009, 10:38 PM
I had two wall tanks very similar to those. They were 4" wide and about 36" long. If I remember correctly they held about 10 gallons. I had small freshwater fish and plants in them.. guppies mostly.
They were horrible tanks!

4" wide you can barely get your hand into and they were a nightmare to clean. They were pretty expensive and a total waste of money. They have been sitting in my storage room for years.

JPotter
03-12-2009, 03:16 AM
My daughter has one and I have one in my office. They are small but OK for small FW set up. I think they would be useless for SW. With the FW they are fine..ours have been up for 2 years. Only disaster was when someone unplugged it and it got cold!

noirsphynx
03-12-2009, 03:28 AM
There's one of those at one of the local stores here. It's one of their display tanks behind the cash with a pair of clowns.