View Full Version : Wire Management Fitting for Kessil
Canadian
09-20-2015, 05:35 PM
Does anyone know where I can get just a single one of these threaded fittings for managing wire length? And even more specifically one that the threads will fit for a Kessil A360WE?
spit.fire
09-20-2015, 07:44 PM
Does anyone know where I can get just a single one of these threaded fittings for managing wire length? And even more specifically one that the threads will fit for a Kessil A360WE?
ive got a bunch of them but not sure what threads the kessil has
if you can figure out what thread it is i can check to see if i have one
Canadian
09-26-2015, 02:49 PM
Thanks! I sent an email to Kessil asking if they could give me specifics on the size and pitch of the threads.
Canadian
09-29-2015, 03:30 AM
Kier at Kessil got back to me today. The threading for the keyring bolt is M5 x 0.8mm. So 5mm diameter with 0.8mm thread spacing.
spit.fire
09-29-2015, 04:44 AM
Kier at Kessil got back to me today. The threading for the keyring bolt is M5 x 0.8mm. So 5mm diameter with 0.8mm thread spacing.
i have a few that use a screw instead of built in threads, ill see if i can find a metric screw that size at work tomorrow, pm me your address and i can ship you one (free of charge) if i can find the screw
Canadian
10-02-2015, 03:33 AM
PM sent
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.